![]() Run the ifconfig command on your developer kit and note down the IP address assigned to eth0 interface if using ethernet, wlan0 interface if using wireless, or l4tbr0 if using the USB device mode Ethernet connection. You’ll need to know the IP address of your Jetson developer kit to connect from another computer. Download VNC® Viewer to the device you want to control from. Connecting to VNC service from another computer If you wish VNC to be available automatically, use the system settings application on your developer kit to enable automatic login. The VNC server is only available after you have logged in to Jetson locally. Reboot the system so that the settings take effect sudo reboot.Gsettings set vnc-password $(echo -n 'thepassword'|base64) Set a password to access the VNC server # Replace thepassword with your desired password.Configure the VNC server gsettings set prompt-enabled false.If you have a Jetson Nano 2GB Developer Kit (running LXDE) mkdir -p ~/.config/autostartĬp /usr/share/applications/sktop ~/.config/autostart/.For all other Jetson developer kits (running GNOME) cd /usr/lib/systemd/user/ The User Mode server can be automatically run on login to the Mac User Account. for each user session you want to create on the Mac. Users must make sure that they do not Log Out, as this will terminate their user mode server Perform steps 1. Enable the VNC server to start each time you log in movements and key strokes, so it can tell when you move the mouse off the edge of your screen. By default VNC Server will only accept the user that started the user mode VNC Server.Setup VNC server on the Jetson developer kit Slower connections will degrade the desktop interaction experience. A fairly fast network connection is needed. Your Jetson developer kit and the other computer need to be on the same network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |